Qualified under MIL-DTL-11195G Type 2

 A single component, HAPS free, corrosion inhibiting coating for use on ammunition.

1.     Color:

Fed Std. 35109

Fed Std. 36231

2.     Volume Solids: 55.5 +/- 1%

3.     Solids by Weight: 75.3 +./- 1%

4.    Viscosity:  70 KU max. (reduced)

5.     DFT: 1.0 – 1.5 mils

6.     Theoretical Coverage @ 1 mil dft: 890 ft²/gallon

7.     Gloss @ 60º:  2 – 8

8.     Dry Time

         Set to Touch:  6 minutes max.

Dry Hard: 12 minutes max..

9.     VOC:  3.5 lbs/gallon (420 grams/liter)

Buy as little as 4 gallons! Call Chance at 800 563-1305 x 101 or email Chance to buy or request a FREE quote. 

APPLICATION

Steel:  Surface must be clean and free of grease, dirt, oil, rust and other contaminants that could interfere with proper adhesion.  Pretreatment with TT-P-490E Type 1 or DOD-P-15328D Wash Primers will give the best adhesion and performance.  When blasting the surface a minimum of SSPC-SP6 is required for best performance.

Aluminum:  Clean with an appropriate cleaner to remove contamination from the substrate.  Pretreat the surface with a wash primer or other conversion coating.

Galvanized and other metals:  Clean and remove surface contamination including oxidation.  Treat with a wash primer to improve adhesion to the substrate.

Note:   Due to wide variations in substrates, surface preparation etc.  It is recommended that the customer check adhesion and compatibility.

Reduction:  Reduce 8 parts of enamel with 1 part of thinner A-A-3007 by volume.

Conventional Spray:

Atomizing Pressure:  45 – 55 psi

Pot Fluid Pressure:  10 – 15 lbs.

Airless Spray:

Tip Size:  0.015 – 0.021” orifice

Atomizing Pressure:  2200 psi minimum

Clean-up:

Clean tools and equipment immediately after use A-A-3007 thinner.

Safety Precautions:

This product is intended for professional use in an industrial environment only.  Consult the Material Safety Data Sheet prior to application.

Products are warranted to meet its internal specifications and are of merchantable quality.  However, the purchaser is solely responsible for the suitability of the product for any particular application.  The purchaser should thoroughly test or qualify the product for serviceability, environmental compliance and health and safety factors prior to use. Further, our total liability is limited to the price of the product or replacement in kind.

Call Chance at 800 563-1305 or email Chance to buy or request a FREE quote.