Environmentally Preferred Parts Cleaner

Conforms to Mil PRF-680B, Type II

Product Data Sheet Safety Data Sheet


PARTS KLEEN II Environmentally Preferred Parts Cleaner is an exceptional solvent degreaser formulated without chlorinated solvents or other hazardous ingredients.  The base for PARTS KLEEN II is a unique high-grade hydrocarbon that provides its strength, has no odor and has a high flash point, allowing safe use on all types of mechanical apparatus.  With its high flash point, PARTS KLEEN II provides an unprecedented degree of user safety.

PARTS KLEEN II Environmentally Preferred Parts Cleaner is strong enough to remove grease, fuel oil, carbon and organic resins yet safe on most plastic and rubber surfaces.  Unlike other solvents, PARTS KLEEN II can be used without extensive protective equipment.  Common sense chemical precautions required. (See MSDS).


  • Near Odorless
  • Contains no water
  • Fully evaporative, leaves no residue
  • No hazardous ingredients as defined by the EPA
  • Conforms to numerous corrosion test requirements
  • High flashpoint


Use undiluted.  PARTS KLEEN II works very well in a drum mounted parts washer or any immersion tank. (Not for use in high pressure enclosed cabinets.) You may also spray or wipe

PARTS KLEEN II on a surface to be cleaned.  Oil, dirt and carbon will flow off surface. If additional cleaning is required, re-apply and agitate with rag or brush.  To speed evaporation, use compressed air or wipe with a dry rag.

Key Physical Characteristics


Physical Property Test Method Typical Value
Boiling Point Range ASTM D-86 370°F (187° C)
Color, Saybolt ASTM D-156 >25
Doctor Test ASTM D-235 Conforms
Flash Point (TCC) ASTM D-56 145° F  (63°C)
Kauri-Butanol No. ASTM D-1133 28
Non-Volatile Residue ASTM D-1353 < 5 mg/100 ml
Physical Form Appearance Clear Liquid
Pounds per Gal, (60° F) Calculated 6.39
Soil Cleaning Test Army Method Conforms
Specific Gravity, (60° F) ASTM D-1298 0.790
Vapor Pressure mm Hg ASTM D-2879 0.48 @ 20° C
Total Benzene Content EPA 8260B <0.5 mg/L
Dichlorobenzene Content EPA 8260B <0.5 mg/L
Phenol Content EPA 420.1 <0.1 ppm
Tetrachloroethene Content EPA 8260B <0.7 mg/L
Trichloroethene Content EPA 8260B <0.5 mg/L
VOC Content 766 gm/L


Safety and Handling Precautions

Always use with adequate ventilation. Rubber gloves are recommended. Treat as combustible liquid. Place rags in a metal sealable container after use to avoid possible spontaneous combustion. Keep container closed. Avoid excessive contact with fumes or liquid. Please read MSDS prior to use.


Product Name Part No. Packaging
PARTS KLEEN II 1157-55 55 Gal. Drums
PARTS KLEEN II 1157-5 5 Gal. Pail
PARTS KLEEN II 1157-15 15 Gal. Drum