Environmentally Preferred Parts Cleaner
|Product Data Sheet||Safety Data Sheet|
NEW II Environmentally Preferred Parts Cleaner is an exceptional solvent degreaser formulated without chlorinated solvents or other hazardous ingredients. The base for NEW II is a unique high-grade hydrocarbon that provides its strength, has no odor and has a high flash point, allowing safe use on all types of mechanical apparatus. With its high flash point, NEW II provides an unprecedented degree of user safety.
NEW II Environmentally Preferred Parts Cleaner is strong enough to remove grease, fuel oil, carbon and organic resins yet safe on most plastic and rubber surfaces. Unlike other solvents, NEW II can be used without extensive protective equipment. Common sense chemical precautions required. (See MSDS).
- Contains no water
- Fully evaporative, leaves no residue
- No hazardous ingredients as defined by the EPA
- Meets all requirements to MIL-PRF-680C, Type II
- Conforms to numerous corrosion test requirements
- High flashpoint
Use undiluted. NEW II works very well in a drum mounted parts washer or any immersion tank. (Not for use in high pressure enclosed cabinets.) You may also spray or wipe NEW II on a surface to be cleaned. Oil, dirt and carbon will flow off surface. If additional cleaning is required, re-apply and agitate with rag or brush. To speed evaporation, use compressed air or wipe with a dry rag.
Key Physical Characteristics
|Physical Property||Test||Typical Value|
|Boiling Range, (IPB – FBP)||ASTM D-86||194-203° C|
|Color, Saybolt||ASTM D-156||> 25|
|Doctor Test||ASTM D-235||Conforms|
|Flash Point (TCC)||ASTM D-56||145° F (63° C)|
|Kauri-Butanol No.||ASTM D-1133||28|
|Non-Volatile Residue||ASTM D-1353||< 5 mg/100 ml|
|Physical Form||Appearance||Clear Liquid|
|Pounds per Gal, (60° F)||Calculated||6.39|
|Soil Cleaning Test||Army Method||Conforms|
|Specific Gravity, (60° F)||ASTM D-1298||0.766|
|Vapor Pressure||ASTM D-2879||0.48 mm Hg @ 20° C|
|Total Benzene Content||EPA 8240/8260B||<0.5 mg/L|
|Dichlorobenzene Content||EPA 8240/8260B||<0.5 mg/L|
|Phenol Content||EPA 420.1||<0.1 ppm|
|Tetrachloroethene Content||EPA 8240/8260B||<0.7 mg/L|
|Trichloroethene Content||EPA 8240/8260B||<0.5 mg/L|
Safety and Handling Precautions
Always use with adequate ventilation. Rubber gloves are recommended. Treat as combustible liquid. Place rags in a metal sealable container after use to avoid possible spontaneous combustion. Keep container closed. Avoid excessive contact with fumes or liquid. Please read MSDS prior to use.